M307 H2 A50 D60 B1 use bang-bang control for the chamber heater with 60 seconds dead time M143 H2 S100 Set temperature limit for heater 0 to 120C M141 H2 Assign chamber heater to heater 0 M906 X1500 Y1500 Z800 E800 I30 Set motor currents (mA) and motor idle factor in per cent M566 X900 Y900 Z12 E120 Set maximum instantaneous speed changes (mm/min) M350 X16 Y16 Z16 E16 I0 Configure microstepping without interpolation M558 P0 H5 F120 T6000 Disable Z probe but set dive height, probe speed and travel speed M574 X1 Y2 Z1 S0 Set active high endstops M555 P2 Set firmware compatibility to look like Marlin Configuration file for Duet WiFi (firmware version 1.17 to 1.19) They can be machined and drilled, which is very useful for connectors, locating pins, magnets, etc. It can be bought from a local store and cut to size. These plates are easy to find and easy to work with. There are many registered names and alloys for this material and equivalents: It’s a cast aluminum alloy milled for flatness. We have decided to choose what is called an “Aluminum Tooling Plate”. However, they are more fragile and also worse thermal conductors. Glasses are more stable than metals in therm of thermal expansion. There are two majors choices when looking for a flatbed: Unless you’ll want to stick with low bed temperature (<70☌), it is strongly advised to upgrade it too. We have reached the limit of this bed and now it is not usable anymore. The plastic on top of the glass started warping and ungluing itself. We had to increase the bed temperature for a high-temperature polymer in particular and something happened… But I’m sure you know what’s is going to happen once we start cranking up the heat. We printed for a while using the original bed and it went well. We had to put the spring loaded connectors away for now and use a standard high-temperature connector. The pivot movement required for removing the build plate was putting a lot of stress on the glue. We tried to clean the surface, sand it, glue it again, and it wouldn’t stick. DyzeXtruder-GT / DyzeXtruder Pro ENP Liquid Cooling BlockĪs we couldn’t thread in the glass, we machined an aluminum block and glued it using high-temperature epoxy.DyzEnd-X/DyzEnd Pro ENP Liquid Cooling Block.Kit DyzEND Pro + DyzeXtruder Pro 1.75mm.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |